Dragees flower box Realization

Supplies: dragees cube box, needle, paper garland of roses, label tag, scissors.

To mount the cube dragees box, start with the background. Press the walls so as to draw the box.Then assemble the bottom, after flattening the bottom edges each other. You will see two diagonals on the outside bottom of the box.

Then fold the flaps of the box towards the inside of the box. Fold the flap last longer because it is the one that covers the bottom. You get the bottom of the box. You have to mount the cover.

Label the lid folds. The folds of the recesses should be folded inwardly downstream folds (hollow).Fold then against the wall of the cover with a flap. The folding thus forms the angle of the lid.Once folded corners, fold the flap to the smallest inside the cover, wedging underneath bent corners. Then fold the largest flap and the cover will be fixed. You just have to put it on the bottom of the box.

Take the paper garland of roses and cut with scissors a piece keeping two flower buds. Keep a few centimeters of thread after each flower. Accollez the two flowers together and form a loop with the wire between the two flowers. Make a loop with the wire and twist it several times on itself to secure it. Then cut with scissors wire loop too. Make two holes on the couverce of the box with a needle. The space between the two holes should correspond to the width of two side to side flowers.

Then move the label tag in a cable end with the two flowers. Make then move each end of the wire into the cover holes. And tighten and tie together the two thread ends under the cover by winding them together. Cut off the excess wire with scissors.